Desk Top Mask Aligner

Mask aligners are used in most microfabrication research laboratories and in even in low- volume production facilities. Almost any microscale device or structure requires more than one photomask step. The job of the contact aligner is to allow its user to align features on a substrate (wafer) to features on a photomask. The production of sophisticated electronic devices may involve ten or more of these alignment steps.

Location

NET building, Department.of Mechanical Engineering
IIT Kanpur

Contact

Prof. Shantanu Bhattacharya

This email address is being protected from spambots. You need JavaScript enabled to view it.